AUSTRALIAN MONITOR MP8 Specifications download pdf (Page 6)

PAGE 6 AMIS MP8 INSTALLATION AND OPERATION MANUAL

Wiring:

Connect the speaker output of the ﬁrst ampliﬁer to INPUT terminals labelled

AMP 1, maintaining correct polarity. Connect the speaker load for this ampliﬁer

to OUTPUT terminals labelled ZONE 1. Repeat for additional ampliﬁers and

speaker loads. Always use appropriate cable for ampliﬁer to MP8 and MP8

to speaker wiring.

Power Requirements:

The MP8 can operate on the supplied plug pack and/or separate 24V DC

power supply.

NOTE About Grounding: It may be necessary in some circumstances

to ground the MP8 to eliminate noise from the monitor speaker. This can be

done using the negative terminal of the 24VDC IN binding post or by making

sure that the chassis is electrically connected to the equipment rack (which

should be grounded).

NOTE About Speaker Isolation: When a zone is selected for

monitoring it is isolated from the other ampliﬁers by 1kohm resistors. The

negative input is also AC referenced to chassis ground with a capacitor.

INSTALLATION

1 2 3 4 5 6 7 8 9 10 11 12

No comments

AUSTRALIAN MONITOR MP8 Specifications Page 6