AUSTRALIAN MONITOR AMC120 Specifications

INSTALLATION AND OPERATION MANUALMIXER AMPLIFIERS AMC+30 AMC+60 AMC+120 AMC+250AMC+ SERIES

HOT SURFACE! DON’T TOUCH HERE!AMC+120 AMC+250PriorityChannel 1 will mute channels 2, 3 and 4. This will only occur when signal appears on channel 1, i

COM 1 2 3 4TONE MODULEOHMDIRECT OUTCC100LINE4 70CLASS 2 WIRING230 V. FUSE T2AH 250VAMC+ 120 115 V. FUSE T4AH 250V Audio AmplifierModel: AMC

AMC+ 30 AMC+ 60 AMC+ 120 AMC+ 250Power Output (0.5%Thd, 1khz) 30W 60W 120W 250WS/N Ratio > 75dBr > 75dBr > 80dBr >85

COMMON TO ALL MODELSThd (1khz, -1db) Better than 0.5%Mic Input SENSITIVITY 1mV @ 200ohm IMPEDANCE 1k3 ohm HEADROOM 77mV (37dB)Aux In

PAGE 14 AMC+ SERIES INSTALLATION AND OPERATION MANUALNOTES

PAGE 15AMC+ SERIES INSTALLATION AND OPERATION MANUALNOTES

ENGINEERED BY AUSTRALIAN MONITOR Address: 1 Clyde Street, Silverwater, Sydney NSW 2128 Australia. Private Bag 149, Silverwater NSW 1811 ABN 78 001 34

1. Read these instructions.2. Keep these instructions.3. Heed all warnings.4. Follow all instructions.5. Do not use this apparatus near water.6.

AMC+ SERIES The Australian Monitor AMC+ series of amplifiers takes the heritage and reliability of our famous AMIS series amplifiers and integrates thes

1 CH 1–4These control the levels for each channel input.2 BassThere is 12dB of cut and boost at 100Hz.3 TrebleThere is 9dB of cut and boost at 10kHz.

COM 1 2 3 4TONE MODULEOHMDIRECT OUTCC100LINE4 70CLASS 2 WIRING230 V. FUSE T2AH 250VAMC+ 120 115 V. FUSE T4AH 250V Audio AmplifierModel: AMC

NOTE: Only connect one output – either Distributed Line or Low Impedance MountingYour amplifier is designed for standard 19” rack mounting and occupies

100V Line70V Line4 ohm voice-coilOUTPUT DISTANCE WIRE SIZE AMC+30 AMC+60 AMC+120 AMC+250100V Up to 50m AWG26(0.12mm2) AWG26(0.12mm2

TROUBLESHOOTING GUIDETrouble Likely Cause RemedyPower LED not on Power not reaching amplifierCheck power switch is onCheck mains connectionCheck mains

PAGE 9AMC+ SERIES INSTALLATION AND OPERATION MANUALBLOCK DIAGRAM