AUSTRALIAN MONITOR PM16 User's Guide download pdf (Page 5)

PAGE 5AMPRO PM12 & PM16 INSTALLATION & OPERATION MANUAL

MONO INPUT CHANNEL SECTION

BALANCE INPUT (MIC)

Electronically balanced inputs accept a standard XLR male connector. + 48V Phantom power available on each input mic socket.

LINE INPUT

Accepts an unbalanced high impedance input signal. (Use for connecting deck, turntable, keyboard etc..)

INSERT

Allows signal to be taken out from the mixer, routed through external equipment such as a compressor, and then back to the mixer to

continue the ﬁnal mix path.

PHANTOM POWER SWITCH

Depressing this switch on each channel applies 48V DC across the microphone input XLR connector for remote powering of condenser

microphones. The LED will be turned on to indicate phantom power is enabled.

IMPORTANT: ONLY turn the +48V

phantom power switch on or off with

all output faders DOWN, to prevent

damage to the mixer or external devices.

LOW CUT

Depressing this switch inserts an 18 dB per octave, 75Hz low cut ﬁlter in the signal path. This is useful on live vocals to reduce stage rumble

or “popping” from microphones. It can also be used to cut low frequency hum.

TRIM

Adjusts the input sensitivity of each channel.

EQ ON

Enables or disables the EQ. When the switch is depressed, the EQ is enabled. When the switch is in the “out” position, the EQ is disabled.

HIGH

Controls the high frequency response of each channel. Provides ±15dB at 12kHz.

1 2 3 4 5 6 7 8 9 10 ... 15 16

No comments

AUSTRALIAN MONITOR PM16 User's Guide Page 5